UPDATE FROM MABULA
I have had a very rough 2 months unfortunately health wise. I was struck 3x in a row with bacterial infections. The second infection occurred  after a routine hospital checkup and I became very sick. I had to rest and take a lot of antibiotics. Once I was recovering and restarting work 1 month ago, I again became sick. The infection was not yet gone, so even more antibiotics and rest was needed. Needless to say, it took a lot of my energy and I needed a lot of rest.
Finally, the infection is really gone and my energy is coming back step-by-step now and I have started work again. I am terribly sorry to have kept you waiting for support. I will address all outstanding questions and e-mails step-by step and will be on the forum daily from today.
APP 2.0.0-beta47 will come soon as well, a lot of work was already completed before I became very ill, so the release is also nearly ready for you. Beta47 will be much faster actually. Many workflows will be more than 2x faster, mosaics can even be 10x faster than before because registration really received a major boost... all compared to beta46. Â Before I release it, I will make sure that everything is working properly and then I will release it.
Hello,
I have a Problem that my flat will be ignored in my Processing.
I try to figure out where is the Problem.
One Question at First the Light and the Flat comes together in step 2 Calibrate?
I just tried very simple
Add one Light one MasterFlat
Then create Masters & assign to lights and then save this calibrated frame.
The result the Light is the same as before
You can load in a light, then load in a calibrated master-flat and in the preview window select "calibrated". The list below should then show the flat being used on the light and you see what it does in the preview window. If the flat is not assigned, something must be wrong with the flat. If you do this, is the flat at least assigned?
No, this didn't work too. No Changes between.
Is it a Problem when the Light comes from FITS and the Flat from CR2 data?
But I did everything already in a Main Flat as FITS
Â
Â
Shouldn't matter as long as the data is processed with APP I think. Could you post a master-flat and one of the lights here just to see?
Thanks, Vincent, for the Help.
The Problem is that APP can't work with CR2 Flats and FITS Lights
Mmm, yes that could be the case then.. didn't realize that as I've never done it like that. I'll ask if Mabula can maybe display a warning about that.
